Silicone Thinner™

Kaufen Sie Smooth-On bei FormX

Smooth-On ist einer der weltweit führenden Hersteller von 3D-Modellierungsmaterialien wie Formenbau-, Gieß- und Spezialeffektmaterialien, industrielle Gießharze, Klebstoffe und Ausrüstung. FormX ist Vertriebspartner von Smooth-On-Produkten in Europa.

Silicone Thinner™ ist eine nicht reaktive Silikonflüssigkeit, die die gemischte Viskosität von Zinnhärtungs- (Kondensation) oder Platinhärtungs- (Addition) Silikonkautschukprodukten verringert.

Silicone Thinner™

Silicone Thinner™ /500ml Verdünner kan verwendet werden, um die Viskosität od Addition und Kondensationshärtende Silikone zu senken. 13,87 EUR

Silicone Thinner™ /3,63kg Verdünner kan verwendet werden, um die Viskosität od Addition und Kondensationshärtende Silikone zu senken. 80,67 EUR

Silicone Thinner™ /18,4kg Verdünner kan verwendet werden, um die Viskosität od Addition und Kondensationshärtende Silikone zu senken. 350,32 EUR

Silicone Thinner™ offers the following advantages:

- A lower mixed viscosity (A+B) means that the rubber will de-air faster when vacuuming.
- Mixed rubber (A+B) will flow better over intricate model detail.
- Silicone Thinner® will lower the ultimate shore hardness (durometer) of cured silicone rubber.
- Pot life (working time) is increased in proportion to the amount of Silicone Thinner® used.

Disadvantage: Ultimate tear and tensile strength are reduced in proportion to the amount of Silicone Thinner® added, however knotty tear properties of the Mold Max® series rubbers are unaffected.
Instructions

Materials should be stored and used in a warm environment 23° C. This material has a limited shelf life and should be used as soon as possible. Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk.

*Silicone Thinner™ is added as a percentage of the total Part A+Part B rubber system. An accurate gram scale must be used. Weigh out and pre-mix required amount of Silicone Thinner™with Part A of silicone rubber before adding Part B. Mix all components thoroughly and vacuum as directed on mold rubber technical bulletin.

It is not recommended to exceed 10% by weight of total system (A+B).

Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.